How To Apply Graphite To Pinewood Derby Car
How To Apply Graphite To Pinewood Derby Car. Tap the wheel several times with your finger to move the graphite throughout the wheel. Here is another tip for increasing the speed of your pinewood.
The result should look something like this. Place the figure on your car. Be sure to wipe excess oil off the axle with a clean cloth.
The Brush Allows You To Get The Graphite Where It Belongs, In Between The Wheel And The Axle.the Jar Of Graphite Includes:
Tap the wheel several times with your finger to move the graphite throughout the wheel. Tap the wheel several times with your finger to move the graphite throughout the wheel. Remove the wheels and axles.
Repeat Steps 2 Through 4 Several Times.
Insert a wheel into an axle. Rub off excess oil on your axles. Here is another tip for increasing the speed of your pinewood.
Carefully Peel A Pad From The Strip And Center It Over Each.
This is burnishing the graphite or breaking it in. Place the figure on your car. Shake the graphite tube then squeeze out several puffs of graphite into the gap between the wheel and the axle.
Insert A Wheel Into An Axle.
Best way is to take a.093 pin gauge. Why graphite coat pinewood derby axles? It is important that the graphite pad is centered on the axle hole so use a sharp pencil and straight edge to mark the horizontal and vertical position of each axle.
The Graphite Falls Off Your Axles Each Time Your Car Races Down The Track.
What important to note is correct rotation of wheels in the forward direction as if the car was traveling down the back. Regarding this, what is the best lubricant for. Detailed instructions on applying graphite to the wheels to get maximum speed from your pinewood derby ® car!
Post a Comment for "How To Apply Graphite To Pinewood Derby Car"